PTFE tape and pipe joint compound

Throttling valves are used to control the amount or pressure of a fluid allowed to pass through, and are designed to withstand the stress and wear caused by this type of operation. A double-tapped bushing is a fitting which serves as a reducer. It is a sleeve similar to a close nipple, but is threaded on both its inner and outer circumferences. Like a reducer, a double-tapped bushing has two threads of different sizes.

Other one is eccentric reducer which is having one edge parallel to connecting pipe due to which air accumulation is not possible. Slip-joint fittings are frequently used in kitchen, bathroom and tub drainage systems. They include a detached slip nut and slip-joint washer; the washer is made of rubber or nylon.

malleable iron pipe fittings manufacturers

They are used to allow an auger (or plumber’s snake) to clean out a plugged drain. Since clean-out augers are limited in length, clean-outs should be placed in accessible locations at regular intervals throughout a drainage system . They are also known as “rodding eyes”, because of the eye-shaped cover plates often used on external versions. These compression connections on water shutoff valves under a kitchen sink show evidence of slow seepage .

Stainless steel and carbon steel press fittings can hold up to 16 bars of pressure. Many companies and individuals use the abbreviation IPS which normally refers to iron pipe size. When we use the term ‘IPS-sized’, or either Mips or Fips , we are referring to pipes with NPT threads.

Why not take a look at our range of stainless steel products or get in touch to speak to a NERO representative today. With sealing cone screw-on ttings with O-ring (AOL / AOS), the pre-stressing of the O-ring must be bridged and the sealing cone must lie metallically ush against the cone of the HL/HS connector. Cutting ring ttings are available with a wide range of standardised screw-in threads, enabling them to be used for an enormous variety of applications. All fittings are designed to withstand the operating pressures specified in the standards, in some cases the requirements of the standard are exceeded. “plumbing – In slip joints, what’s the difference between rubber and nylon washers? – Home Improvement Stack Exchange”.